Nazarian Para PMC enjoys FRESH Gun Forums So will you.
Jüt ip

 

 


Version Française


Norsk versjon




This site is Gunny Approved

 

Sharps rifle


Sharps Model 1852 "Slanting Breech" Carbine, open for loading, two primer-tapes

Other Pictures:
Sharps rifle

Original 1863 carbine in .50-70 Government.

Sharps rifles were a series of large bore single shot rifles that began with a design by Christian Sharps in 1848. Sharps rifles have been historically renowned for long range and high accuracy. By 1874 the rifle was available in a variety of calibers and had been adopted by the armies of a number of nations and was one of the few successful designs to transition to metallic cartridge use.
Reproductions of the Sharps rifle are currently made by different rifle companies and the rifle has become an icon of the Old West due to its use in a number of movies in the Western genre.

History
Sharps` initial rifle was patented September 12, 1848 and manufactured by A. S. Nippes at Mill Creek, (Philadelphia) Pennsylvania.
The second model used the Maynard tape primer, and surviving examples are marked Edward Maynard - Patentee 1845. In 1850 the second model was brought to the Robbins & Lawrence Company of Windsor, Vermont where the Model 1851 was developed for mass production. Rollin White of the R&L Co. invented the knife-edge breech block and self-cocking device for the "box-lock" Model 1851. This is referred to as the "First Contract", which was for 5,000 Model 1851 carbines - of which approximately 1,650 were produced by R&L in Windsor.
In 1851 the "Second Contract" was made for 15,000 rifles and the Sharps Rifle Manufacturing Company was organized as a holding company with $1,000 in capital and with John C. Palmer as president, Christian Sharps as engineer, and Richard S. Lawrence as master armorer and superintendent of manufacturing. Sharps was to be paid a royalty of $1 per firearm and the factory was built on R&L`s property in Hartford, Connecticut.
The Model 1851 was replaced in production by the Model 1853. All Sharps rifles were manufactured in Windsor until October 1856. Christian Sharps left the company in 1853; Richard S. Lawrence continued as the chief armorer until 1872 and developed the various Sharp models and their improvements that made the rifle famous.
The 1874-pattern Sharps was a particularly popular rifle that led to the introduction of several derivatives in quick succession. It handled a large number of .40- to .50-caliber cartridges in a variety of loadings and barrel lengths.
Hugo Borchardt designed the Sharps-Borchardt Model 1878, the last rifle made by the Sharps Rifle Co. before its closing in 1881.
Reproductions of the paper cartridge Sharps M1859 and M1863 Rifle and Carbine, the metallic cartridge 1874 Sharps Rifle, and Sharps-Borchardt Model 1878 are being manufactured today. They are used in Civil War re-enacting, hunting and target shooting.

replica panerai watches

Sharps military rifles and carbines
The military Sharps rifle (also known as the Berdan Sharps rifle) was a falling block rifle used during and after the American Civil War. Along with being able to use a standard percussion cap, the Sharps had a fairly unusual pellet primer feed. This was a device which held a stack of pelleted primers and flipped one over the nipple each time the trigger was pulled and the hammer fell - making it much easier to fire a Sharps from horseback than a gun employing individually loaded percussion caps.
The Sharps Rifle was produced by the Sharps Rifle Manufacturing Company in Hartford, Connecticut. It was used in the Civil War by the U.S. Army Marksman, known popularly as "Berdan`s Sharpshooters" in honor of their leader Hiram Berdan. The Sharps made a superior sniper weapon of greater accuracy than the more commonly issued muzzle-loading rifled muskets. This was due mainly to the higher rate of fire of the breech loading mechanism and superior quality of manufacture.
At this time however, many officers were distrustful of breech-loading weapons on the grounds that they would encourage men to waste ammunition. In addition, the Sharps Rifle was expensive to manufacture (three times the cost of a muzzle-loading Springfield rifle) and so only 11,000 of the Model 1859s were produced. Most were unissued or given to sharpshooters, but the 13th Pennsylvania Reserves (which still carried the old-fashioned designation of a "rifle regiment") carried them until being mustered out in 1864.

Sharps military carbine
The carbine version was very popular with the cavalry of both the Union and Confederate armies and was issued in much larger numbers than the full length rifle. The falling block action lent itself to conversion to the new metallic cartridges developed in the late 1860s, and many of these converted carbines in .50-70 Government were used during the Indian Wars in the decades immediately following the Civil War.
Some Civil War-issue carbines had an unusual feature: a coffee mill in the stock.
Unlike the Sharps rifle, the carbine was very popular and almost 90,000 were produced. By 1863, it was the most common weapon carried by Union cavalry regiments, although in 1864 many were replaced by 7-shot Spencer carbines. Some Sharps clones were produced by the Confederates in Richmond. Quality was generally poorer and they normally used brass fittings instead of iron.

Sharps sporting rifles
Sharps made sporting versions from the late 1840s until the late 1880s. After the American Civil War, converted Army surplus rifles were made into custom firearms, and the Sharps factory produced Models 1869 and 1874 in large numbers for commercial buffalo hunters and frontiersmen. These large-bore rifles were manufactured with some of the most powerful black powder cartridges ever made. Sharps also fabricated special long-range target versions for the then-popular Creedmore style of 1,000-yard (910 m) target shooting. Many modern black powder cartridge silhouette shooters use original and replica Sharps rifles to target metallic silhouettes cut in the shapes of animals at ranges up to 500 meters. Shiloh Rifle Manufacturing Company, and C Sharps Arms of Big Timber, Montana, have been manufacturing reproductions of the Sharps Rifle since 1983 and 1979, respectively.

In film and television Some movies which showed the strengths of the Sharps rifle are Billy Two Hats (1974), Rancho Deluxe (1975), Valdez Is Coming (1971), Quigley Down Under (1990), and True Grit (2010). In the 1990 western Quigley Down Under, Tom Selleck`s title character uses a Sharps rifle that has a 34" barrel length, as opposed to the standard 30" length. In Valdez Is Coming, Burt Lancaster`s character, Bob Valdez, uses a Sharps against character Frank Tanner`s men at 1200 yards. As a result of the popularity of the film Quigley Down Under, a Sharps match is held annually in Forsyth, Montana known as the "Quigley Match". A 44-inch target is placed at 1,000 yards for each shooter, remniscent of a scene from the movie. Theater Crafts Industry went so far as to say, "In Quigley Down Under, which we did in 1990, the Sharps rifle practically co-stars with Tom Selleck." This statement was echoed by gunwriters including John Taffin in Guns and Lionel Atwill in Field & Stream. Firearms manufacturers such as Davide Pedersoli and Shiloh Rifle Manufacturing Company have credited these movies with an increase in demand for those rifles.
On television, the Sharps rifle plays a central role in the murder investigation in the pilot episode of the Longmire series (2012). A Sharps is the weapon used in the murder, and its firing action is central to the climactic action sequence.

www.rmskull.com

Weapontype:
Rifle, Carbine

Operation:
Falling Block

Cartridge:
.52-caliber 475-grain projectile with 50-grain (3.2 g) cartridge, later converted to .45-70 Government in 1873.

Weight:
9.5 lb (4.3 kg)

Length:
47 inches (1,200 mm)

In Production:
1850–1881

Sights:
open ladder type

Effective range:
500 yd (460 m)

Muzzle Velocity:
1,200 ft/s (370 m/s)

 

All rights 2024 Nazarian.no